●精密導向V型槽，可調整到無間隙，精密程度甚至可取代工裝的導向裝置（2.5KN HKP/E除外）
●可拆卸的接口夾持裝置可從前面安裝工裝，通過使用該裝置，
可產生很大的夾緊力卻從不會損傷工裝的被夾持部位
●壓力機頭的導向平面加工精度為H7級
●通過操縱回轉手柄調整具有高精度螺距的傳動絲杠，壓力機頭
與工作臺面之間的距離可以迅速得到調節
●工作臺表面的T型槽可方便壓緊工件
●吼深和機體高度可根據需要加長
●工作臺表面寬的T型槽方便壓緊工件
●可通過安裝使用用戶訂制的不同配件，大幅度擴展應用范圍
●對于8/12KN和16KN HKPV型，壓力可從8KN提高到12KN，
或從8KN提高到16KN，只需簡單更換承重螺栓。沖程高度大
約減少25mm。
●The 360 degree adjustable handle lever allows the most favourable lever position for each respective procedure （not 2.5kN HKP/E）
●The precise and non-floating adjustable V-guide guarantees accurate working, even with tools without guidance （not 2.5kN HKP/E）
●The detachable spigot clamp allows frontal loading. By means of the spigot clamp a high holding force is achieved without damage to the fixing spigot
●The head of the press is guided by an H7 manufactured flat guidance
●The daylight can be quickly and easily adjusted by means of a fine pitch thread operated by a crank handle （not 2.5kN HKP/E）
●Table with wide T-grooved clamping surface
●Extended gap and height frames can be extended further if required （not for 2.5kN HKP/E and 2.5kN HKPV）
●The range of application can be substantially expanded by means of customer-specific accessory equipment
●For models 8/12 kN and 8/16 kN HKPV, the pressure force can be increased from 8kN to 12kN, or from 8kN to 16kN respectively, by simply changing the bearing bolt of the toggle lever. The height of stroke is thereby reduced to ca. 25mm
●By comparison our toggle presses reach there listed nominal force at the bottom dead centre with a lever operating force of 400 to 100N （4 to 10 kg）
|
